ABB PST Series Installation And Commissioning Manual page 137

1SFC132003M0201
  %\3DVV IDXOW W\SH RI RSHUDWLRQ
3DWK LQ PHQX
0HQX6(77,1*6)XQFWLRQDO 6HWWLQJV
)DXOWV%3 )DXOW 2S
This parameter makes it possible to select between three
different actions of the softstarter when the protection is
activated. It is active only if the by-pass monitor protection
is selected.
Stop–M
Stop–A
3DUDPHWHU 'HIDXOW YDOXH
WH[W
BP Fault Stop–M
Op
  +LJK FXUUHQW ZDUQLQJ
3DWK LQ PHQX
0HQX6(77,1*6)XQFWLRQDO 6HWWLQJV
:DUQLQJV:DUQ , +LJK
If the function is selected, a warning signal will be given
provided that the current during full voltage is higher than
the set value. The measurement starts 30 seconds after
IXOO YROWDJH is reached.
3DUDPHWHU 'HIDXOW YDOXH 6HWWLQJ UDQJH
WH[W
Warn No
I=High
The motor stops and a manual reset is
required before restart.
The motor stops and an automatic reset is
performed when the fault disappears
6HWWLQJ UDQJH
Stop–M, Stop–A
Yes, No
&KDSWHU 
)XQFWLRQV
'HVFULSWLRQ
Type of opera-
tion for Bypass
fault
'HVFULSWLRQ
High current
warning
137