ABB PST Series Installation And Commissioning Manual page 99

)LJXUH  3ULQFLSOH RI D ILHOGEXV QHWZRUN ZLWK 367
VRIWVWDUWHUV FRQQHFWHG
1SFC132003M0201
&KDSWHU  )LHOGEXV FRPPXQLFDWLRQ
RSWLRQ
  2YHUYLHZ
The PST softstarter has an interface on the front for
connecting the ABB fieldbus plug (eplug) used for fieldbus
communication. Through this interface it is possible to
control the softstarter, achieve status information, as well
as up and down-load of parameters.
The interface between the softstarter and the eplug is
always the same. Independent of softstarter size or
delivery date it is possible to connect any fieldbus protocol
later on since this is defined in the eplug itself.
Following fieldbus protocols are available
• AS-I
• DeviceNet
  5HTXLUHG DFFHVVRULHV
To connect the softstarter to a fieldbus system, following
accessories are required:
• Fieldbusplug for present fieldbus protocol (check that
the cable length is sufficient).
• Connectors for bus connection.
• End plug (some protocols).
• Software for PLC set-up.
)LHOGEXV FRPPXQLFDWLRQ RSWLRQ
&KDSWHU 
99