ABB PST Series Installation And Commissioning Manual page 69

5GVVKPI +G #
5VQTG
)LJXUH  6HWWLQJ ,H PHQX
5GVVKPI +G
0GZV
)LJXUH  &RQILUPLQJ 6HWWLQJ ,H
1. %NCUU
5VQTG
)LJXUH  2YHUORDG FODVV
1. %NCUU
0GZV
)LJXUH  &RQILUPLQJ 2/ &ODVV
'ZV $[2CUU ;GU
5VQTG
)LJXUH  &RQILUPLQJ 2/ &ODVV
'ZV $[2CUU
0GZV
)LJXUH  &RQILUPLQJ 2/ &ODVV
4GCF[!
;GU 6WPG 5GV
)LJXUH  5HDG\"7XQH 6HW PHQX
1SFC132003M0201
#
$CEM


$CEM
;GU
$CEM
6HWWLQJ ,
H
Set the current that the softstarter will be exposed to i.e.
rated motor current if the unit is connected In Line.
)RU XQLWV FRQQHFWHG ,QVLGH 'HOWD WKH 6HWWLQJ ,
DFFRUGLQJ WR WKH FXUUHQW LQ WKH GHOWD FLUFXLW
RI WKH UDWHG PRWRU FXUUHQW
e
1 3
3UHVV 6WRUH WR VDYH WKH GDWD DIWHU VHWWLQJ WKH FXUUHQW
Confirm the 6HWWLQJ , by pressing 1H[W. If wrong Setting I
H
was set, press %DFN and set the correct value.
2YHUORDG FODVV 2/ &ODVV
Select the class for the overload relay for the used
application type. Available classes:
• 10
• 10A
• 20
• 30
Press 6WRUH to save the selected class.
Confirm the selected overload class by pressing 1H[W. If
wrong overload class was selected, press %DFN and select
the correct class.
([WHUQDO %\3DVV FRQWDFWRU ([W %\3DVV
If an External By-Pass contactor is used, set the
parameter to <HV, otherwise 1R.
Press 6WRUH to save the data.
Confirm the selection of external by-pass by pressing
1H[W. If wrong selection was made, press %DFN and
correct the selection.
7XQH 6HW
The configuration of the application setting menu is now
completed. If no tuning of the settings is wanted, it is
possible to return to the top level by pressing <HV.
If tuning of some main parameters is wanted, select 7XQH
6HW.
&KDSWHU 
6HWWLQJV DQG FRQILJXUDWLRQ
PXVW EH VHW
H

e
69