Dimm - NEC Express5800 Series Maintenance Manual

Chapter 2 Configuring and Upgrading the System
5.5

DIMM

The DIMM (dual inline memory module) is installed to the DIMM socket in the CPU/IO module on the
Express5800/ft series.
The motherboard of CPU/IO module has 16 sockets for DIMM.
Tips
•
Maximum memory capacity is as follows:
– R320c-M4 model, R320c-E4 model: Up to 256GB (16GB x 16)
•
In the error messages and logs in POST or ftsmaint command of NEC ESMPRO, the
DIMM connector may be described as "group". The number next to "group"
corresponds to the slot number shown in the figure on the next page.
•
Important The DIMM is extremely sensitive to static electricity. Make sure to touch the
metal frame of the server to discharge static electricity from your body before
handling the DIMM. Do not touch the DIMM terminals or onboard parts with a
bare hand or place the DIMM directly on the desk.
•
Make sure to use the DIMM authorized by NEC. Installing a third-party DIMM may
cause a failure of the DIMM as well as the server. Repair of the server due to
failures or damage resulted from installing such a board will be charged.
•
Before adding or removing DIMMs, power off the server and detach the CPU/IO
module.
•
Refer to Chapter 2 (5.1.2 Anti-static measures) and Chapter 2 (5.1.4 Preparing
your system for upgrade) before starting installing or removing options.
Motherboard of the CPU/IO module
Express5800/R320c-E4, R320c-M4 Maintenance Guide (VMware)
5. Installing Optional Devices
DIMM slot 1
DIMM slot 2
DIMM slot 3
DIMM slot 4
DIMM slot 8
DIMM slot 7
DIMM slot 6
DIMM slot 5
DIMM slot 9
DIMM slot 10
DIMM slot 11
DIMM slot 12
DIMM slot 16
DIMM slot 15
DIMM slot 14
DIMM slot 13
121