Replacing Pci Board - NEC Express5800 Series Maintenance Manual

Chapter 2 Configuring and Upgrading the System

5.7.4 Replacing PCI Board

Follow the procedure below to replace the failed PCI card.
(1)
<Other than N8803-038 Fibre Channel Board Set>
1. Identify the failed board by ftsmaint command.
2. Remove the CPU/IO module referring to Chapter 2 (5.4.1 Removing CPU/IO Module).
3. Remove the PCI bracket, then remove the PCI card.
4. Replace the board and secure it.
5. Refer to Chapter 2 (5.4.2 Installing CPU/IO Module) and install the CPU/IO module.
6. Connect the network cable and cables for option devices.
7. The installed CPU/IO module will start automatically.
8. Confirm that the PCI card is recognized correctly by the OS.
(2)
N8803-038 Fibre Channel Board set
1. Identify the failed board by ftsmaint command.
2. Remove the CPU/IO module referring to Chapter 2 (5.4.1 Removing CPU/IO Module).
3. Configure WWPN of Fibre Channel board to be installed (setting/confirming access control) by
using control software such as iStorageManager.
4. Remove the PCI bracket, then remove the PCI card.
5. Replace the board and secure it.
6. Refer to Chapter 2 (5.4.2 Installing CPU/IO Module) and install the CPU/IO module.
7. Connect the network cable and cables for option devices.
8. The installed CPU/IO module will start automatically.
9. Confirm that the PCI card is recognized correctly by the OS.
144
Express5800/R320c-E4, R320c-M4 Maintenance Guide (VMware)
5. Installing Optional Devices