Mitsubishi Electric AE-200A Instruction Book page 41

Note: When setting a schedule for a block or all groups, all operation modes are available for selection, but the available operation
modes depend on the unit model. The units will not operate in the selected mode not supported by the units.
Note: About Optimized Start function
26ºC
• If [Optimized Start] is selected, the operation mode and the set temperature need to be set as well. The Optimized Start
function will start the units 5 to 60 minutes prior to the scheduled start time to reach the set temperature at the scheduled
start time, based on the operation data in the past. (When the units start the first time after a power reset, the units will
start operation 30 minutes before the scheduled start time.)
• [Optimized Start] can be selected only for the air conditioning unit groups.
• If the room temperature is measured by the return air temperature sensor on the air conditioning unit, the measured value
may not be an accurate representation of the temperature in the room, especially when the air conditioning unit is stopped
and the room air is stagnant. When this is the case, use an external temperature sensor (PAC-SE40TSA) or remote
controller sensor to measure the room temperature.
• If [Optimized Start] is selected and the [Prohibit Remote Controller] setting is set to Prohibit or Permit at the same time,
the operations from the remote controllers will be prohibited or permitted at the scheduled start time.
[4] Saving the schedules
(1) To undo the changes made, touch [Cancel] before
saving the schedules.
After completing the settings, touch [OK] to save the
schedules.
Note: To delete each scheduled events, touch the "Delete"
button in the row of the schedule to be deleted.
WT07190X01
Cool ON
Room
temperature
8:45 9:00
Operation mode: Cool
Start time: 9:00
Set temperature: 26ºC
24ºC
Heat ON
8:40 9:00
Operation mode: Heat
Start time: 9:00
Set temperature: 24ºC
41
Room
temperature
OK
Delete
Cancel