Mitsubishi Electric AE-200A Instruction Book page 64

(2) Touch the [Unit Info.] tab.
Referring to section 5-2-5, make necessary basic settings, and
then touch [Save Settings].
Note: Make sure to set the [System Exp] setting for the AE-200 to
[Expand].
(3) Touch the right triangle button to display the [Network] tab, and
touch it.
Referring to section 5-2-6, make sure that [AE200] is selected
as [Controller], set the AE-200's IP address and subnet mask,
and then touch [Save Settings].
The AE-200 will reboot.
Note: Refer to section 5-2-1 "Logging in to the Initial Settings menu"
for how to log in.
(4) In the [Controller] section, select [AE1], [AE2], or [AE3] to
make settings for each AE-50.
Referring to section 5-2-6, set the IP address of each AE-50
that is connected to the AE-200, and M-NET address, and
then touch [Save Settings].
(5) Touch the [Groups] tab.
Referring to section 5-2-7, select [AE200], [AE1], [AE2], or
[AE3] in the [Controller] section, make group settings for
each AE-200/AE-50, and then touch [Save Settings] on each
settings screen.
(6) Make the following settings, as required.
● Interlock settings (See section 5-2-8 "Interlocked LOSSNAY".)
● Block settings (See section 5-2-9 "Blocks".)
● Floor layout settings (See section 5-2-10 "Floor Layout".)
WT07190X01
64