5. Initial startup settings
5-1. Initial startup setting procedures
5-1-1. AE-200 initial start-up for a system without connection to an AE-50 controller
(1) After the power is turned on, a language selection screen will
appear.
Select the language to be used for display, and then touch [OK].
Note: It will take approximately one minute for the display to appear
after the power is turned on.
Note: Once the initial settings have been made, [Monitor/Operation]
screen will appear after the power is turned on.
(2) The [Date and time] screen will appear.
Referring to section 5-2-3, set the current date, current time,
and daylight saving time, and then touch [Save Settings].
(3) Touch the [Unit Info.] tab.
Referring to section 5-2-5, make necessary basic settings, and
then touch [Save Settings].
Note: Make sure to set the [System Exp] setting for the AE-200 to [Do
not expand].
(4) Touch the right triangle button to display the [Groups] tab, and
touch it.
Referring to section 5-2-7, make group settings, and then
touch [Save Settings].
WT07190X01
61