Siemens SINUMERIK 840 User Manual page 113

07.90
The following parameters must be defined prior to call:
Parameters Description
R08 Extended T address (see Section 2.2)
R09 T number (tool number) (see Section 2.2)
R10 = 0 No automatic tool offset
> 0 Automatic tool offset (see Section 2.2)
R11 = 0 Without empirical and average value
> 0 Empirical value memory No./mean value memory No. (see Section 2.3)
R22 Probe number (see Section 2.6)
R23 = 25 Multi-point measurement on circumference
R24 Number of measuring points on circumference
R25 Variable measuring speed in mm/min
R25=0 Standard cycle value
R26= 0-359.5 Indexing angle = Start angle (only positive)
R27 = 1...R
Number of measurements at same location (typically 1...3)
max
R28 = 1...R Multiplication factor for measurement path "2a"
max
R29 = 1...R Weighting factor k for averaging (typically 1...3)
max
R30 = 1...3 Number of measuring axis (see Section 2.12)
R33 Zero offset range
R34 Average value compensation
R36 Safe area
R37 Dimensional difference check
R40 Upper tolerance limit
R41 Lower tolerance limit
R42 Set value
* The set value must be specified as a negative value when measuring
below the turning centre in plus X direction.
See Section 10.2 for result display parameters.
©
Siemens AG 1990 All Rights Reserved
SINUMERIK 840/850/880 (BN)
4 Measuring Cycles for Turning Machines
4.3.5 L974 Multi-point measurement on circumference
(according to drawing)
(according to drawing)
(according to drawing)
6FC5197- AB70
4–39