Siemens SINUMERIK 840 User Manual page 47

1 Introduction
1.9.2 Logging via CP315 with the SINUMERIK 840/880
– Log output, supplementary lines
R38=xxxxxxxx
R39=111022x can be assigned for logging submeasuring points.
x=1 ... 8: Number of supplementary lines
R39=11110230 can be assigned if a tolerance violation of one or several setpoints is
ascertained after the measurement. In addition, the submeasuring points concerned
must be marked in R38. The relevant setpoint difference is then marked with a special
character.
– End of log, logging of measurement results
R39=11911311
End of log causes page feed to be activated and deselects the "Logging" mode in the
PLC. The preceding log must be concluded with "End of protocol" before every new
log (e.g. new header data, new part program for format description).
– Line feed
R39=1111035x
x=1 ... 9
The 0th digit in identification parameter R39 specifies the number of space lines. Up to
9 space lines can be programmed. Page feed does not cause the space lines to be
transferred to the next page.
– Page feed
– Page feed selectively programmed
R39=11100361
Page feed can be programmed selectively, e.g. after "End of measurement result
logging".
– Automatic page feed
Automatic page feed is always generated if:
– a page is full.
– a new log header is called.
1–38
0 = Do not mark line
1 = Mark line
1st Supplementary line
.
.
8th Supplementary line
©
Siemens AG 1990 All Rights Reserved
10.91
6FC5197- AB70
SINUMERIK 840/850/880 (BN)