Siemens SINUMERIK 840 User Manual page 129

5 Measuring Cycles for Milling Machines and Machining Centres
5.1.3 L976 Calibrating workpiece probe in any hole (plane)
Example: Calibrating workpiece probe 3 in the X-Y plane
The probe length (Z axis) must have been input in the TO memory prior to cycle call, e.g. D98
(in this case value 50).
%MPF 9764
N1 T200
N5 G59 X100 Y50
N10 G54 G17 G00
N15 D98 Z10
N20 R22=3 R23=2
R28=1 R32=100
N25 L976
N20 M30
The new trigger values are stored in the relevant MDC areas.
5–10
Z0
X100 Y80
R25=0 R27=1
R33=0 R36=1
©
Siemens AG 1990 All Rights Reserved
T No. probe
Load ZO values
Probe at centre point and
ZO selection
Selection of length compensation
Position probe in hole
Parameters for calibrating cycle
Cycle call for calibrating in the
X-Y-plane
6FC5197- AB70
SINUMERIK 840/850/880 (BN)
07.90