Siemens SINUMERIK 840 User Manual page 50

10.91
• Suggestion for a solution
Prerequisites: configuration of the computer link via CP315, configuration of the FB
package subfunctions "Logging of measurement results" and "PLC controlled data output"
and activation of the logging function via MDC.
The following procedure is then suggested:
– Preparation of a part program for configuring the form. The part program is as
follows:
%MPF 200
( @C*80 )
Part 1
( @L*72 )
( @F*1*1 @--------@ @-------------@ @-------------@ @-------------@
@------------@ @-------------@ @--------@ )
( @F*2*1 @I@ )
( @F*2*80 @I@ )
( @F*3*1 @I part number.......:@ )
( @F*3*52 @Datum:@ )
( @F*3*71 @Seite:@ )
( @F*3*80 @I@ )
( @F*4*1 @I@ )
( @F*4*80 @I@ )
( @F*5*1 @I order number....:@ )
( @F*5*80 @I@ )
( @F*6*1 @I@ )
( @F*6*80 @I@ )
( @F*7*1 @I program number....:@ )
( @F*7*45 @ serial number......:@ )
( @F*7*80 @I@ )
( @F*8*1 @------@ @-------------@ @-------------@ @-------------@
Part 2
@-------------@ @-------------@ @---------@
( @F*9*1 @I@ )
( @F*9*80 @I@ )
( @F*10*1 @I measuring@ @points@ )
( @F*10*15 @setpoint@ @
@ point Tim@ @e of day@ )
( @F*10*80 @I@ )
( @F*11*1 @I@ )
( @F*11*42 @+@ )
( @F*11*51 @-
( @F*11*80 @I@ )
( @F*12*1 @------@ @-------------@ @-------------@ @-------------@
@-------------@ @-------------@ @---------@ )
( @V*3*23 @R40*F8.0 )
( @V*5*23 @R41*F8.0 )
( @V*7*23 @R43*F8.0 )
( @V*7*65 @R44*F8.0 )
( @D*3*58 )
( @S*3*77 )
©
Siemens AG 1990 All Rights Reserved
SINUMERIK 840/850/880 (BN)
1.9.2 Logging via CP315 with the SINUMERIK 840/880
actual@ @value
@ @ difference@ )
6FC5197- AB70
1 Introduction
toleran@ @ce limit set@
1–41