Siemens SINUMERIK 840 User Manual page 212

7 Measuring in JOG Mode (SINUMERIK 880/880 GA2)
7.2.1 Operating and function sequence
JOG
Workpiece measurement
Tool offset
Workpiece probe
Emp. value memory no.
Setpoint 200.000
Actual value
Actual position
X 0.000
Y 0.000
Z 0.000
A1 0.000
B1 0.000
MEASURING ACTIVE
STORE
Display after the softkey MEASURE has been pressed
6. The axis which is first traversed from zero speed and the direction define the
direction of measurement and only with this value is it possible to traverse
the workpiece probe with the set measuring speed as in JOG mode.
Until the probe has been deflected, it is only possible to traverse along this
axis in this direction. All other axes, directions and rapid traverse remain
disabled.
It is possible to reduce the set measuring speed with feedrate override.
The measuring speed depends on the machine
(See information supplied by the machine tool
7–12
D 2 Axis name L1
1 Axis name L2
10 ZO (fine)
Empirical value
REPOS offset
X 0.000
Y 0.000
Z 0.000
A1 0.000
B1 0.000
configuration.
manufacturer).
©
Siemens AG 1990 All Rights Reserved
X
Z
G57
0.025
6FC5197- AB70
SINUMERIK 840/850/880 (BN)
01.93
1. 1