1.9.2.5 Error Messages Of Logging Function; Example Demonstrating The Logging Of Measurement Results For The Sinumerik - Siemens SINUMERIK 840 User Manual

10.91

1.9.2.5 Error messages of logging function

• Error message of auxiliary cycle L988
"Check MDC(N7000)":
"PLC interface not ready":
• Error character when logging
Part number . . . . . . . . . .
Order number . . . . . . . .
Program number . . . . . .
Measuring
Setpoint
point
18 –9999.333
**** –99999.333 –99999.333
19 #####
20 44.000
Explanation:
##### Measuring data exceeding the specified format.
**** Measuring point number in R45 too long
1.9.2.6 Example demonstrating the logging of measurement results for
the SINUMERIK 840/880
• Task definition
– Workpiece drawing
The axially symmetric workpiece shown is to be measured with a probe after it has
been machined. The measuring data are logged.
©
Siemens AG 1990 All Rights Reserved
SINUMERIK 840/850/880 (BN)
1.9.2 Logging via CP315 with the SINUMERIK 840/880
Is generated, if MDC 7000.1 and MDC 7000.6 are not set
when L988 is called.
Is generated if the coordination bit is not reset by the PLC
within 5 seconds.
: 1002458 Date: 24.12.88
: 1000000001
: 1234
Tolerance limit
Actual
value
+
–9999.333 –1.999
#####
##### 1.200
44.000 1.200
6FC5197- AB70
1 Introduction
Page: 1
Setpoint Time of
difference
–
–1.999 –1.999 11:39:28
2.500 –1.700 11:39:29
##### –1.700 11:39:30
2.500 –1.700 11:39:31
day
1–39