Siemens SINUMERIK 840 User Manual page 206

7 Measuring in JOG Mode (SINUMERIK 880/880 GA2)
7.1.1 Operating and function sequence
7. As soon as the probe has been deflected, the traversing axis (measuring
axis) is stopped and the selected tool geometry is calculated. The derived
tool length is displayed (tool length).
The dialog text MEASURING ACTIVE is deleted and the STORE softkey is
enabled.
JOG
Tool measurement
Tool offset
Tool probe
Tool type
Empir. value memory no.
Tool length 120.231
Actual position
X 0.000
Y 0.000
Z 0.000
A1 0.000
B1 0.000
STORE
Display after probe has been deflected
8. When you press the softkey STORE, the measured tool length is stored in
STORE
the selected tool offset memory. The P no. within the selected tool offset
memory in which the determined value is entered is derived from the
measurement plane, the measuring axis and the tool type.
Which measuring axis wear memory is deleted depends on the machine
configuration.
The machine data defines whether the wear memory is
(See information supplied by the machine tool
7–6
T0 area
D 5 Measurement parameter
1 (Measure radius
3 (Measure L1
10 (Measure L2
Empirical value
REPOS offset
X 0.000
Y 0.000
Z 0.000
A1 0.000
B1 0.000
deleted or not.
manufacturer).
©
Siemens AG 1990 All Rights Reserved
1
2
-> 0)
-> 1)
-> 2)
0.020
6FC5197- AB70
SINUMERIK 840/850/880 (BN)
01.93
1. 1