Frames
6.6 Programmable scale factor (SCALE, ASCALE)
Additive instruction, ASCALE X Y Z
You can program scale changes, which are to be added to existing frames by using the
ASCALE command. In this case, the last valid scale factor is multiplied by the new one.
The currently set or last programmed coordinate system is used as the reference for the
scale change.
Note
If you program an offset with ATRANS after SCALE, the offset values are also scaled.
254
TRANS
AROT
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Fundamentals