Lubrication; Greasing The Bearings And Bushings - Toro Groundsmaster 3300 Series Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Before each use or daily—Grease
the PTO driveshaft (cross-bearings
and telescoping splines).
Every 50 hours—Grease the bearings and
bushings.
The machine has grease fittings that you must
lubricate regularly with No. 2 lithium grease.
Important:
Lubricate the machine immediately
after every washing.
•
Idler arm (Figure 40)
Figure 40
1. Idler arm
•
PTO driveshaft (Figure
Important:
Grease the driveshaft before each
use or daily.
41)
1. Grease fittings
•
Axle pivot pin
1. Axle pivot pin
g300631
•
Front of the machine
– Attachment pin joints(2)
– Lift-cylinder bushings (2)
– Lift-arm pin joints (2)
42
Figure 41
(Figure 42)
Figure 42
(Figure 43):
g303694
g308668