Cab Controls - Toro Groundsmaster 3300 Series Operator's Manual

Attachment Lift Switch
The attachment lift switch raises the attachment to the
highest position (i.e., the T
lowers the attachment to the lowest position (i.e., the
O ) position.
PERATING
•
Raise the attachment: Press the rear of the
switch.
•
Lower the attachment: Press the front of the
switch.
Raise the attachment to the T
whenever you transport the machine between
locations. Lower the attachment to the O
position whenever you are not using the machine.
PTO Switch
•
Engage the PTO: Pull up on the switch.
•
Disengage the PTO: Push the switch down.
The only time you should engage the PTO is when the
PTO attachment is in the O
to the ground with the driveshaft connected) and you
are ready to begin operation.
Note:
If you leave the operator's seat while the
PTO switch is in the O
automatically shut off the engine; refer to
the PTO Function (page
Key Switch
The key switch has 3 positions: O
and S .
TART
Use the switch to start or shut off the engine [refer
to Starting the Engine (page 34)
Engine (page 34)] or to review the display-screen
information [refer to Understanding the Display-Screen
Information (page 27)].
Throttle-Control Switch
Use the switch to adjust the engine speed.
•
Increase the engine speed: Press and release
the front part of the switch to increase the speed
by 100 rpm. Press and hold to increase the speed
to the maximum amount.
•
Decrease the engine speed: Press the rear
part of the switch to decrease the speed by 100
rpm. Press and hold to decrease the speed to the
minimum amount (idle).
Display Screen
The display screen shows information about your
machine, such as the operating status, various
diagnostics, and other information.
Refer to Understanding the Display-Screen
Information (page 27)
information.
position) and
RANSPORT
position
RANSPORT
PERATING
position (lowered
PERATING
position, the machine will
N
Resetting
34).
, O /P
FF N REHEAT
or Shutting Off the
for more display-screen
Display Screen Button
Refer to Using the Display-Screen Button (page

Cab Controls

Machines Equipped with a Cab
1. Windshield-wiper switch
2. Fan-control knob
3. Light switch
Windshield-Wiper Switch
,
Use the switch
wipers on or off.
Fan-Control Knob
Rotate the fan-control knob
the speed of the fan.
Light Switch
Press the switch
on or off.
Temperature-Control Knob
Rotate the temperature-control knob
regulate the air temperature in the cab.
Air-Conditioning Switch
Use this switch
on or off. Use the fan-control knob to control the
air-conditioning.
Note:
The engine rpm rises when you turn on the
air-conditioning.
21
Figure 22
4. Temperature-control knob
5. Air-conditioning switch
(Figure 22) to turn the windshield
(Figure 22) to regulate
(Figure 22) to turn the dome light
(Figure
(Figure 22) to turn the air conditioning
27).
g300626
22) to