Starting The Engine; Resetting The Pto Function; Shutting Off The Engine; After Operation - Toro Groundsmaster 3300 Series Operator's Manual

Canceling a Parked or Recovery Regeneration
Use the P R
ARKED EGEN
C setting to cancel a running parked or recovery
ANCEL
regeneration process.
1. Access the DPF Regeneration menu, scroll
down to the P
ARKED
R R
ECOVERY EGEN
2. Press the next screen to cancel a Parked Regen
or cancel a Recovery Regen.

Starting the Engine

1. Sit on the operator's seat and fasten the seat
belt.
2. Ensure that the parking brake is engaged and
the PTO is disengaged.
3. Preheat the engine by rotating the key switch to
the O /P
N REHEAT
Note:
An automatic timer controls the preheat
for 6 seconds.
4. Rotate the key to the S
engine for no longer than 15 seconds, and allow
the key to return to the O
Note:
If additional preheating is required,
turn the key to the O
O /P position. Repeat this process as
N REHEAT
needed.
5. Move the throttle to idle speed or partial throttle
and run the engine until it warms up.

Resetting the PTO Function

Note:
If you leave the operator's seat while the
PTO switch is in the O
automatically shut off the engine.
Perform the following to reset the PTO function:
1. Push down the PTO switch.
2. Start the engine; refer to
(page 34).
3. Pull up the PTO switch.

Shutting Off the Engine

1. Use the throttle control to lower the engine
speed.
2. Move the PTO switch to the O
3. Rotate the key switch to the O
remove the key from the switch.
C or R
ANCEL ECOVERY
R option or the
EGEN
option.
position.
position, crank the
TART
/P position.
N REHEAT
position, then to the
FF
position, the machine will
N
Starting the Engine
position.
FF
position and
FF

After Operation

R
EGEN

After Operation Safety

General Safety
•
Shut off the engine, remove the key, and wait
for all movement to stop before you leave the
operator's position, Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
•
If the cutting units are in the transport position, use
the positive mechanical lock (if available) before
you leave the machine unattended.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Remove the key and shut off the fuel (if equipped)
before storing or hauling the machine.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Maintain and clean the seat belt(s) as necessary

Servicing the Cutting Unit

You can rotate the cutting unit from the T
position (A in
Figure 30). Use the S
cutting unit blades or clean underneath the cutting
unit; refer to your cutting unit Operator's Manual.
34
Figure 30) to the S
ERVICE
position to maintain the
ERVICE
RANSPORT
position (B in