Product Overview; Controls; Traction Pedal - Toro Groundsmaster 3300 Series Operator's Manual

the recommended pressure setting for the
attachment.
•
Rotate the adjusting screw clockwise to
increase the pressure.
•
Rotate the adjusting screw counterclockwise
to decrease the pressure.
Attachment
Rotary cutting unit
Flail Mower (Model No.
02835)
Snowthrower
Snow Blade (Model No.
23350)
Snow Broom
9. Shut off the engine and remove the key.
10. Tighten the jam nut at the end of the
weight-transfer spool, and torque the nut to 13
to 16 N∙m (10 to 12 ft-lb).
11. Install the cap on the test port.
12. Remove the pressure gauge from the test port.
Weight-Transfer Pressure
1,724 kPa (250 psi)
1,379 kPa (200 psi)
1,724 kPa (250 psi)
1,379 kPa (200 psi)
1,724 kPa (250 psi)

Product Overview

1. Cutting unit

2. Traction pedal

3. Hydraulic-fluid tank
4. Steering wheel
5. Console
6. Operator's seat

Controls

Traction Pedal
Note:
Adjust the seat position before you operate the
machine. Refer to the seat kit Installation Instructions
for seat-adjustment instructions.
Use the traction pedal
machine forward or rearward.
•
Move the machine forward: Use your toes to
press the top of the pedal.
•
Move the machine rearward: Use your toes to
press the bottom of the pedal.
Note:
You can achieve steady operation by keeping
your heel on the platform and pressing the pedal with
your toes.
Ground speed is proportionate to how far the pedal
is pressed. For maximum ground speed, you must
fully press traction pedal while throttle is in the F
position. Maximum speed forward is 24 km/h (15
mph).
19
Figure 18
7. Roll bar
8. Hood/engine compartment
9. Battery
10. Fuel tank
11. Parking brake
12. PTO shaft
(Figure 19) to move the
g219621
AST