Huawei NetCol5000-C Series User Manual page 108

NetCol5000-C030 In-row Chilled Water Smart Cooling
Product
User Manual (Simple Configuration)
Parameter
adjust
Cool shortage
filter time
Note: In the V100R002 software versions (main control board 2), DIP switch is replaced
by the Teamwork CAN resistor enable parameter. If teamwork is not set onsite, remain
the parameter in OFF. If teamwork is set, change the parameters of the first and last units
to ON, and remain the others in OFF. View the software version by taping About on the
main screen.
Step 3 Complete the teamwork settings for all the smart cooling products by performing
Step
Step 4 On the home screen of any teamwork controlled smart cooling product, tap
teamwork control succeeds, the teamwork topology of the smart cooling product in the group
is displayed, as shown in
Figure 4-18 Teamwork topology
Table 4-7 Note for the screen
No.
1
Issue 09 (2020-01-10)
Description
temperature after the
chiller linkage function
is enabled. The value
must be greater than
5° C but not greater than
UP limit for water temp
adjust.
Indicates the time
required for adjusting
the water temperature if
the current water
temperature cannot
meet the requirement
due to workload
changes. The value
range is 0–7200s.
2.
Figure
Parameters
ON/OFF/NA
Copyright © Huawei Technologies Co., Ltd.
Configuration
Principle
that the default chiller
water temperature set
in the NMS is
consistent with the
lower limit on the
adjustment water
temperature.
It is recommended
that the parameter be
set to the value of
CFT stability filter
delay.
4-18. Table 4-7 describes the note for the screen.
Note
On indicates the smart cooling product is started
and Off indicates the smart cooling product is shut
down. NA indicates the smart cooling product is
offline.
4 ACC Introduction
Default Value
60s
Step 1 and
. If the
99