Setting Conference Parameters - Huawei RP100-55T User Manual

HUAWEI RP100-55T Room Presence
User Guide

5.3 Setting Conference Parameters

The factory settings and default settings of the conference parameters can help the conduct of
conferences. The parameters can also be set based on actual requirements.
To initiate a dual-stream conference, set the video and H.239 parameters. To initiate a
single-stream conference, only the video parameters need to be set. For details about the
dual-stream mode, see section 5.4 Setting Up an H.239 Dual-Stream Conference.
To set conference parameters, do the following:
Step 1 Select Settings > Conference, and then set the parameters listed in Table 5-2.
Table 5-2 Conference parameters
Parameter
Audio protocol
Video protocol
Video resolution
Video frame rate
Enable H.239
Dynamic bandwidth
Conference line
type
Issue 01 (2013-12-20)
Description
This specifies the audio protocol used by the RP100-55T to encode
and decode the audio.
This specifies the video protocol used by the RP100-55T to encode
and decode the video. In a non-multi-stream conference, the video
protocol is the video protocol used by the local RP100-55T.
You can select a proper format based on the video protocol that is
already set.
When the video protocol is set to auto, the video format can be
Sharp or Smooth.
When Sharp is selected, the system prioritizes the frame rate. When
Smooth is selected, the system prioritizes the video resolution.
This specifies the video frame rate, that is, the frequency at which
the imaging device produces unique frames. The higher the frame
rate, the smoother and clearer the video. It is recommended that you
select Auto.
After this check box is selected, presentations can be shared during
point-to-point calls.
If this function is enabled, when the ratio of the packet loss caused
by insufficient bandwidth in the network increases, the RP100-55T
decreases the conference bandwidth automatically until the packet
loss does not occur constantly in the network or the conference
bandwidth is decreased to 64 kbit/s. Using the policy of dynamically
adjusting the bandwidth, the RP100-55T can stabilize the bandwidth
within one minute after packet loss occurs in the network.
 When the network condition is good, select Disable.
 When the network condition is poor, select Enable.
This specifies the type of the line used during a multipoint
conference.
If Auto is selected and the RP100-55T is registered with a GK, an
IP line is preferentially used for the multipoint conference.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
5 Conference Initiation
39