Siemens SINUMERIK 840D Function Manual page 879

⇒ Cyclic: Set position = actual position
Note
DB31, ... DBX1.4 (follow-up operation) is relevant only for DB31, ... DBX2.1 == 0 (controller
enable)
Position measuring system 1/2 (DB31, ... DBX1.5 and 1.6)
Switchover of the position measuring system for the FS and LS is possible during synchronous
operation. The coupling is retained.
Note
It is recommended to switchover the position measuring system for FS and LS only for
deselected synchronous operation.
Delete distance-to-go / spindle reset (DB31, ... DBX2.2)
LS: Setting spindle reset during synchronous operation
The setting of spindle reset causes the LS to be braked to standstill with the parameterized
acceleration. Synchronous operation remains active.
Any superimposed movement, other than together with COUPON / COUPONC, will be completed
as fast as possible.
Spindle stop (feed stop) (DB31, ... DBX4.3)
LS and FS: Setting spindle stop during synchronous operation
The setting of "spindle stop" for FS or LS causes both spindles to be braked synchronous to
standstill. Synchronous operation remains active.
Resetting spindle stop
Once "spindle stop" has been reset for both spindles, reacceleration is made to the last valid
speed setpoint.
Application example
Bring FS and LS to a standstill when a protection door is opened during synchronous operation.
Signal characteristic for LS and FS:
1. Stop: DB31, ... DBX4.3 = 1 (spindle stop)
2. Waiting for standstill: DB31, ... DBX61.4 == 1
3. Stopping: DB31, ... DBX2.1 = 0 (controller enable)
Axes and spindles
Function Manual, 06/2019, A5E47437747B AA
S3: Synchronous spindle
19.4 Special features
879