Parameter Assignment; Supplementary Conditions; Incremental Manual Traversing; Function - Siemens SINUMERIK 840D Function Manual

H1: Manual traversing

17.5 Incremental manual traversing

● Orientation axis 2:
– DB21, ... DBX336.6 (orientation axis 2: Travel command "minus") or
– DB21, ... DBX336.7 (orientation axis 2: Travel command "plus")
● Orientation axis 3:
– DB21, ... DBX340.6 (orientation axis 3: Travel command "minus") or
– DB21, ... DBX340.7 (orientation axis 3: Travel command "plus")
Note
A travel command set in JOG mode is canceled if the controller enable or pulse enable for the
axis to be traversed is missing. The travel command must therefore be set again after release
of the axis.
17.4.2

Parameter assignment

Jog or continuous mode
The selection of jog or continuous mode for the continuous procedure is performed NC-
specifically for all axes via the setting data:
SD41050 $SN_JOG_CONT_MODE_LEVELTRIGGRD (jog/continuous mode for JOG
continuous)
Jogging mode is the default setting.
17.4.3

Supplementary conditions

Indexing axis
An indexing axis always stops at an indexing position both in jog mode and in continuous mode.
In jog mode, the indexing axis traverses to the next indexing position in the direction of travel,
for example, when the traversing key is released
17.5 Incremental manual traversing
17.5.1

Function

With incremental traversing, the operator specifies the number of increments to be traversed by
the axis via the machine control panel.
646
Axes and spindles
Function Manual, 06/2019, A5E47437747B AA