HP 3000 Series Handbook page 160

Error Code
Hex( Dec)
3B(59)
3C(60)
3D(61)
3E(62)
3F(63)
40(64)
41(65)
42(66)
43(67)
44(68)
45(69)
46(70)
47(71)
48(72)
49(73)
4A(74)
4B(75)
4C(76)
4D(77)
4E(78)
4F(79)
thru
7F(127)
80(128)
81(129)
82(130)
83(131)
84(132)
85(133)
86(134)
87(135)
88(136)
89(137)
8A(138)
8B(139)
8C(140)
8D(141)
For HP Internal Use Only
Table 5-50. DERROR Status Codes {continued)
Description
SPES gain not within acceptable level.
Reserved.
Reserved.
Write current unsafe.
That command requires a special test enable to be executed.
Unknown write fault.
Write during loss of servo timing sync.
Write during momentary spindle off-speed indication.
Write during momentary actuator off-track indication.
Write during a seek operation.
Write after settle or tracking failure.
Write following aggressive settle.
Write following inhibit DSP code 7 is not defined.
Write was attempted while ESDI attention was asserted.
Write was attempted while an illegal head was selected.
Write was attempted while a recalibrate was in process.
Write was attempted on a head that was in the head alignment critical state.
Write was attempted while a head alignment was in process.
Write was attempted after a fatal head alignment occurred.
Write was attempted while spun down or after a recalibrate failure.
Reserved.
No failure detected.
Unsupported command.
Illegal command sequence.
Servo heartbeat time out.
Spindle stuck.
Spindle couldn't reach full speed.
Servo PLL didn't lock.
Index pattern fault.
TMR2 Alignment failure.
Servo PLL came unlocked.
Bad hard track number.
Settle failure.
Alignment Band AGC voltage not within legal range.
Heroics invoked during spin up.
5-56 Troubleshooting