For HP Internal
use
Only
Internal Peripheral Assembly and Disassembly
The following sections describe the removal and replacement of the replaceable assemblies of
each of the internal peripherals.
DDS-Format OAT Drive Assembly and Disassembly
This section describes the removal and replacement of the drive replaceable assemblies.
Note
"
• New drives do not include mounting hardware. You must remove the
mounting hardware from the old drive and install it on the new drive.
• Make sure the configuration of the new drive is the same as the old drive
(see Figure 4-12).
Replaceable Assemblies
The DDS drive is normally replaced as an entire assembly. However, the front panel may be
replaced as a subassembly.
8-52
Replaceable Parts