Sense Key Codes - HP 3000 Series Handbook

I
VALUE
(HEX)
0
1
2
3
4
5
6
7
8
A
For HP Internal Use Only
Table 5-54. Sense Key Codes
DESCRIPTION
NO SENSE. No specific Sense Key information to be reported, or the command executed
prior to the REQUEST SENSE command completed successf
RECOVERED ERROR. Last command completed successfully with some recovery action
performed by the logical unit.
NOT READY. Logical unit cannot be accessed.
MEDIA ERROR. READ or WRITE command terminated with an error condition, or drive
encountered problems loading or unloading tape.
HARDWARE ERROR. Controller detected a hardware failure while executing a command
or performing a self-test.
ILLEGAL REQUEST. Illegal parameter in the command descriptor block or in additional
parameters supplied as data for a command.
UNIT ATTENTION. Media has been exchanged, logical unit has been reset, or MODE
SELECT parameters have been changed.
WRITE-PROTECTED. Logical unit attempted to write on a write-protected tape.
BLANK CHECK. Logical unit encountered End Of Data (EOD).
COPY ABORTED. COPY or COPY AND VERIFY command aborted due to an error
condition on the source device, destination device, or both.
B ABORT COMMAND. Command was aborted.
5-70 Troubleshooting