HP 3000 Series Handbook page 180

VALUE
{HEX)
For HP Internal Use Only
Table 5-56. Drive Error Codes (continued)
DESCRIPTION
AF Mode change too slow
BO Unable to clean up after test
Bl Utility data not valid
B2 Diagnostic command aborted by host
B3 Illegal diagnostic requested
B4 Illegal loopcount specified
B5
Diagnostic required tape
B6 Diagnostic required no tape
B7 Diagnostic test not supported
B8
Error on calibration, reel did not start
B9 Error on calibration, reel did not stop
BA
Timed out, waiting for Done state
BB No ATF lock
BC
ATF edge not found
BD Bad ATF window
BE Invalid Malcolm firware revision
co
Invalid DDS Group
Cl Invalid DDS End Of Data
C2 Invalid DDS System
C3
No Group Subdata
C4 Append Point Unreadable
C5
Unreadable Subdata
C6
Position Lost
C7
Drive Timeout
C8
Tape Snapped
C9 Write Velocity Fault
5-76 Troubleshooting