8Mm Tape Drive (A3024A) Configuration; Floppy Disk Drive Configuration - HP 3000 Series Handbook

For HP Internal Use Only
8mm Tape Drive (A3024A) Configuration
The location of the address jumpers on the 8 mm tape drive is shown in (xref fig12gsa>. Set
the address to one of the valid addresses, shown in Figure 4-18. Address 7 is reserved and can
not be used as a device address.
Grounding
Hole
Ground
Tab
Pin
SCSI
Address
Jumpers
Power
Resistor
Terminators
Figure 4-17. Smm Tape Drive (A3024A) Configuration
0
2 3
4
5
Figure 4-18. Smm Tape Drive (A3024A) Address Jumper Settings
Floppy Disk Drive Configuration
The jumpers for configuring the floppy disk drive are shown in Figure 4-19.
Refer to Table 4-23. The SCSI ID address of the drive should always be set to
3.
Note
A logical 1 is indicated by the absence of a jumper.
6
WBCE046
Jumpers must always be on H, Hl. and H2. This sets the floppy disk density to 2 MB.
Jumpers must always be on HDS, and PAR.
Configuration 4-45