Fujitsu TeamPoS 2000 Installation And Maintenance Manual page 106

TeamPoS 2000
4. Thread the connecting wire of the MSR through the
shim up to the black insulation.
5. Connect the small white connector to the side of
the LCD. The connector has a key so it will only
fit one way.
6. Slide the metal brace through the shim and into the
side of the back panel. There are three grooves that
act as guides. It only fits one way.
Push the shim and MSR brace into the LCD until
they fit snuggly against the D15. The 3 screw
holes in the brace will line up with the three screw
holes on the back of the D15. Use the 3 screws
provided with the MSR kit to secure the MSR.
7. Reattach the access panel by inserting the tabs at
the left first and then snapping the right tabs into
place.
After installation power up and test MSR with test
card.
5.9.7.4 SmartPoSKeyPad Installation
A 5 x 8 keypad can be installed on any of the D15 models:
1. Place the D15 face down on a clean surface, making sure there is nothing that will
damage the screen. The bottom edge of the unit should be nearest to you.
Remove the left-side gray access cover and the contrasting end cap. (See MSR
installation)
5-50 Rev 3.0
MAINTENANCE MANUAL
90000291