Fujitsu TeamPoS 2000 Installation And Maintenance Manual page 167

TeamPoS 2000
14. Disconnect the hard disk drive signal cable from the riser card.
15. Remove the right and left screws from the top of the riser card.
16. Slide the riser card toward the left of the two tabs on the right side, then lift and
remove the card.
17. Disconnect the cables between the riser card and the front fan from the front lower
right part of the device. (See diagram section 5.6).
18. To mount the riser card again, reverse the removal procedure.
Note: When mounting the riser card again, lower the card so that it is held between the
three rails under the main unit, and then insert the card into the two upper and
lower tabs on the front of the main unit.
90000291 Rev 3.0
MAINTENANCE MANUAL
7-27