Teamcombo Board. Ports 1 And 2 Connector Signals - Fujitsu TeamPoS 2000 Installation And Maintenance Manual

TeamPoS 2000
The following tables contain the connector signals for the ports on the TeamCOMBO
Board. A diagram of each connector and its pin out locations is shown after each table.

5.4.3 TeamCOMBO Board. Ports 1 and 2 Connector Signals

Note: Pin outs may differ depending on jumper placement, see section 5.4.2.
5-20
Connector type: Male D9
PIN # Signal When
DCT Power Mode
1 NC
2 RX
3 TX
4 DTR
5 SG
6 DSR
7 RTS
8 CTS
9 +5V
Rev 3.0
MAINTENANCE MANUAL
Signal when
Standard Com
Mode
CD
RX
TX
DTR
SG
DSR
RTS
CTS
RI
90000291