Table of Contents
Advertisement
TeamPoS 2000
If the integrated pole is long, it will come with two
metal brackets. Install the metal brackets as shown and
then secure metal brackets and integrated stand with
two screws removed in Step 1. Please note there is a
left and right bracket.
3.
Route the display end of the cable (flat connector) through the base, the pole and the
display tilter. Rotate the cable as required to get it through the pole. Install second half
of the pole.
4.
Remove the plastic connector cover from the display, by pulling up on the tab.
5.
Connect the appropriate display cable flat connector to the display. Ensure the key tabs
are down (display side) and locked into place.
6.
Attach the grounding wire to the display using the
provided screw.
5-64
Rev 3.0
MAINTENANCE MANUAL
90000291
Hide quick links:
Advertisement
Table of Contents
