Fujitsu TeamPoS 2000 Installation And Maintenance Manual page 121

TeamPoS 2000
7. Route the cable as shown. Putting the heat shrink
section in the connector opening will make it easier
to install the display connector cover.
8. Install connector cover by inserting the right side tab
(as viewed from the back of the display) into the
display and then pushing down on the left side.
Note: The customer display can be mounted so that it is to the left, right or center of the
pole, depending upon which display slots are selected.
9. Install the tilter part by first inserting the tilter tabs (3) into the display slots and then
securing with a screw.
10. Insert the tilter into the pole and push it until it
locks into place.
11. Mount display pole in the display pole stand.
Align the opening of the pole (tape side) with
the insert on the LCD stand back-end and push
with sufficient pressure to lock the pole in
place. Do not remove the tape.
90000291 Rev 3.0
MAINTENANCE MANUAL
5-65