Fujitsu TeamPoS 2000 Installation And Maintenance Manual page 215

TeamPoS 2000
CMOS BATTERY HAS FAILED
CMOS battery is no longer functional. It should be replaced.
CMOS CHECKSUM ERROR
Checksum of CMOS is incorrect. This can indicate that CMOS has become corrupt. A
weak battery may have caused this error. Check the battery and replace if necessary.
DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER
No boot device was found. This could mean that either a boot drive was not detected or
the drive does not contain proper system boot files. Insert a system disk into Drive A: and
press <Enter>. If you assumed the system would boot from the hard drive, make sure the
hard drive is inserted correctly and all cables are properly attached. Also be sure the disk
is formatted as a boot device and no floppy is inserted. Then reboot the system.
DISKETTE DRIVES OR TYPES MISMATCH ERROR - RUN SETUP
Type of floppy drive installed in the system is different from the CMOS definition. Run
Setup to reconfigure the drive type correctly.
ERROR ENCOUNTERED INITIALIZING HARD DRIVE
Hard drive cannot be initialized. Be sure the adapter is installed correctly and all cables
are correctly and firmly attached. Also be sure the correct hard drive type or Auto is
selected in Setup.
ERROR INITIALIZING HARD DISK CONTROLLER
Cannot initialize controller. Make sure the IDE cable is correctly and firmly installed in
the riser slot. Be sure the correct hard disk type or Auto is selected in Setup. Also check
to see if any jumper needs to be set correctly on the hard disk.
FLOPPY DISK CNTRLR ERROR OR NO CONTROLLER PRESENT
Cannot find or initialize the floppy drive controller. Make sure the floppy drive cable is
seated correctly and firmly. If there is no floppy drive installed, be sure the Floppy Drive
selection in Setup is set to NONE.
KEYBOARD ERROR OR NO KEYBOARD PRESENT
Cannot initialize the keyboard. Make sure the keyboard is attached correctly and no keys
are being pressed during the boot.
If you are purposely configuring the system without a keyboard, set the error halt
condition in Setup to HALT ON ALL, BUT KEYBOARD. This will cause the BIOS to
ignore the missing keyboard and continue the boot.
90000291 Rev 3.0
MAINTENANCE MANUAL
9-11