Configuring Static Route - Huawei B2368 User Manual

LTE CPE B2368
User Guide

7.2 Configuring Static Route

Use this screen to view and configure IPv4 static routes on the LTE Device. Click Network
Setting > Static Route to open the following screen.
Figure 7-2 Network Setting >Static Route
The following table describes the Labels in this screen.
Table 7-1 Network Setting > Static Route
Label
Add New
Static Route
#
Active
Status
Route Name
Destination IP
Gateway
Subnet Mask
Interface
Modify
Issue 03 (2019-01-31)
Description
Click this to set up a new IPv4 static route on the LTE Device.
This is the number of an individual static route.
This indicates whether the route is active or not.
A yellow bulb signifies that this static route is active. A gray bulb
signifies that this static route is not active.
This shows whether the static route is currently in use or not. A yellow
bulb signifies that this static route is in use. A gray bulb signifies that
this static route is not in use.
This is the name that describes or identifies this route.
This parameter specifies the IPv4 IP network address of the final
destination. Routing is always based on network number.
This is the IPv4 IP address of the gateway. The gateway is a router or
switch on the same network segment as the device's LAN or WAN
port. The gateway helps forward packets to their destinations.
This parameter specifies the IP network subnet mask of the final
destination.
This indicates which interface handles the traffic forwarded by this
route.
Click the Edit icon to go to the screen where you can set up a static
route on the LTE Device.
Click the Delete icon to remove a static route from the LTE Device.
Copyright © Huawei Technologies Co., Ltd.
7 Static Route
66