The Dmz Screen - Huawei B2368 User Manual

LTE CPE B2368
User Guide
Label
LAN Start Port
LAN End Port
LAN IP Address
Protocol
Apply
Back

8.3 The DMZ Screen

Use this page to set the IP address of your network DMZ (if you have one) for the LTE
Device. All incoming packets received by this LTE Device's WAN interface will be forwarded
to the default server you set.
Click Network Setting > NAT > DMZ to display the following screen.
Figure 8-4 Network Setting > NAT > DMZ
The following table describes the fields in this screen.
Table 8-3 Network Setting > NAT > DMZ
Label
Default Server
Address
Apply
Cancel
Issue 03 (2019-01-31)
Description
This shows the port number to which you want the LTE Device to
translate the incoming port. For a range of ports, enter the first number
of the range to which you want the incoming ports translated.
This shows the last port of the translated port range.
Enter the inside IP address of the virtual server here.
Select the protocol supported by this virtual server. Choices are TCP,
UDP, or TCP/UDP.
Click Apply to save your changes.
Click Back to return to the previous screen without saving.
NOTE
The configuration you set in this screen takes priority than the Network Setting > NAT > Port
Forwarding screen.
Description
Enter the IP address of your network DMZ host, if you have one. 0.0.0.0
means this feature is disabled.
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
Copyright © Huawei Technologies Co., Ltd.
8 Network Address Translation (NAT)
73