The Reset Button - Huawei B2368 User Manual

LTE CPE B2368
User Guide
LED
WPS /W
i-Fi
LTE
Signal
Strength
LAN
0-2
Refer to the Quick Start Guide for information on hardware connections.

1.5.3 The RESET Button

To reboot the device, just press down the RESET BUTTON and hold for 3-10 seconds, and
then release the button.
To restore the device to the factory default configuration, make sure the POWER LED is on
(not blinking) and press the RESET BUTTON for over 10 seconds.
If you forget your password or cannot access the web configurator, you can use the RESET
BUTTON at the back of the device to reload the factory-default configuration file. This
Issue 03 (2019-01-31)
COLOR STATU
S
Blinking
Off
Green On
Blinking
Yellow Blinking
Off
Green On
Blue On
Orange On
Blinking
Yellow On
(Giga
Ethernet)
Blinking
Green On
(Fast
Ethernet)
Blinking
Off
Copyright © Huawei Technologies Co., Ltd.
Description
A telephone connected to the phone port has its
receiver off of the hook and there is a voice message in
the corresponding SIP account.
The phone port does not have a SIP account registered.
Either IEEE 802.11bgn or 802.11ac is activated.
The LTE Device is communicating with wireless
clients.
The LTE Device is setting up a WPS connection.
The wireless network is not activated.
Strong LTE signal: SINR ≥ 10 dB
Medium LTE signal: 10 dB > SINR ≥ 4 dB
Weak LTE signal: SINR < 4 dB
No LTE signal, searching, or disconnected.
The LTE Device has a successful 1000 Mbps Ethernet
connection with a device on the Local Area Network
(LAN).
The LTE Device is sending or receiving data to/from
the LAN at 1000 Mbps.
The LTE Device has a successful 10/100 Mbps
Ethernet connection with a device on the Local Area
Network (LAN).
The LTE Device is sending or receiving data to/from
the LAN at 10/100 Mbps.
The LTE Device does not have an Ethernet connection
with the LAN.
1 Introduction
7