GE LOGIQ E9 Service Manual page 289

GE
D 5573152-100, R
IRECTION
8-2-5 Tools needed for servicing the LOGIQ E9
In addition to the standard tools listed in
(TORX bits or drivers) are needed to service the LOGIQ E9. If the torque is not indicated with the
procedure, hand tighten the screws/nuts.
Table 8-1
SCREWDRIVER
PHILLIPS SCREWDRIVER
OPEN END WRENCH
TORQUE WRENCH
ADJUSTABLE WRENCH
* 90 degree "L" is suggested. A full set of 90 degree "L" Torx wrenches are
recommended.
** Heavy mechanical parts may need a specific torque. Each procedure will indicate the
torque needed.
8-2-6 PPE Required During Service
The following PPE are required during service tasks, per EHS Policy:
• Safety Glasses
• Safety Shoes
• Cut Resistant Gloves
• Kneel pad (if kneeling is required)
. 2
EV
Tools used for servicing LOGIQ E9
TOOL TYPE
TORX
FLAT BLADE
HEX KEY
PRY BAR
Chapter 8 Replacement procedures
Section 10-5 "Tools Required" on page
TOOL SIZE
BIT # TX-10
BIT # TX-15
BIT # TX-20
BIT # TX-25
BIT # TX-30*
BIT # Tx-45*
1/4 inch or 6 mm
PH1
PH2
PH3
5 mm
8 mm
10 mm
5 mm
10 mm
13 mm
3/16 inch
Up to 81 Nm (59.7 lbf-ft)**
152 mm (6 inches) long
approximately 18 inches overall (457 mm)
LOGIQ E9 S M
ERVICE ANUAL
10-8, the following tools
8 - 5