GE LOGIQ E9 Service Manual page 310

GE
D 5573152-100, R
IRECTION
8-4-10 Verifications after the software has been loaded
NOTE: DO NOT use this procedure if all partitions on the HDD have been erased during the software
load, but refer to: 8-4-9 "Setup after Software loading" on page 8-25.
NOTE: Use this procedure if only the software on C:\ has been replaced or updated or reloaded.
1.) With your recordings from before the software loading available, continue with the setup instructions
starting in: Section 3-7 "Configuration" on page 3-31. Correct the settings as needed.
2.) Continue with: Section 3-9 "Connectivity Setup and Tips" on page 3-35. Based on your recordings,
correct the settings as needed.
3.) Continue with: Section 3-10 "Setup paperwork" on page 3-36. Based on your recordings, correct
the settings as needed.
4.) After a software load, you should always calibrate the Front End, as described in: Section 6-4 "DC
Offset Calibration" on page 6-18.
5.) Next, continue with: 8-4-10-1 "Functional Checks" on page 8-26.
8-4-10-1 Functional Checks
Perform the following functional checks to confirm the system is operational before returning the system
to the customer.
If all are successful, include the following debrief script: LOGIQ E9 Service Manual, Direction
5573152-100, Rev. 2. Equipment passed all required checks and is ready for use.
See:
Section
4-2-2
4-2-3
4-3-13
4-3-5
4-3-7
4-3-17
4-3-17-6
8 - 26
. 2
EV
Table 8-3 Verifications after software has been loaded Functional Checks
Functional Check
Power ON/Boot Up
Power shut down
Probe/Connectors Checks
B-Mode Checks
System CFM and PWD Checks
Mechanical Function Checks
Software DVR (Option) Configuration
Functional Checks
(if present)
Section 8-4 - Loading / Reloading / Upgrading the Software
Debrief Script
LOGIQ E9 Service Manual, Direction
5573152-100, Rev. 2. Equipment passed all
required checks and is ready for use.
LOGIQ E9 S M
ERVICE ANUAL