GE LOGIQ E9 Service Manual page 31

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5573152-100, R

Human safety (cont'd)

When the top console is in its locked position, the gas shock is compressed and

stores mechanical energy. During normal operation the top console, the weight of

the monitor and the mechanical force of the gas shock are in balance. Take care if/

when you activate this gas shock. Personal injury can occur after the panel is

removed and the shock pressure is released. Take care when you repair the

elevation assembly.

Ensure that the system is turned off and unplugged.

Wait for at least 20 seconds for capacitors to discharge as there are no test points to verify isolation.

The Amber light on the Op Panel On/Off button will turn off.

Beware that the Main Power Supply, Extended Power Shutdown and Back End Processor may be

energized even if the power is turned off when the cord is still plugged into the AC Outlet

Risk of electrical shock, system must be turned off and disconnected from power

source. Cord must be controlled at all times.

discharge as there are no test points to verify isolation. The Amber light on the Op Panel On/Off

button will turn off.

Beware that the Main Power Supply, Extended Power Shutdown and Back End Processor may be

energized even if the power is turned off when the cord is still plugged into the AC Outlet

Use extreme caution as long as THE LOGIQ E9 is un-stable, not resting on all four

Tilting the console requires two people in order to avoid injury to service personnel

and damage to the equipment.

Beware of possible sharp edges on all mechanical parts. If sharp edges are

encountered, the appropriate PPE should be used to reduce the risk of injury.

The appropriate PPE is required per EHS Policies and SRA's.

Wear all PPE including gloves as indicated in the chemical MSDS.

Chapter 1 Introduction

Wait for at least 20 seconds for capacitors to