GE LOGIQ E9 Service Manual page 497

GE
D 5573152-100, R
IRECTION
Table 8-131 BEP removal - R4.x and later
5. Release the lock connector for the BEP to
Backplane cable, J2 (left) on a MRX
Configuration.
Or, the Backplane cable, J3 (right) and J5
PCIe to the Card Rack on a GFI
Configuration, using a BEP6. Keep the
cable to transfer to the replacement BEP.
6.
Slide:
• the entire BEP away from the system approximately one inch, then finish removing the Printer
Tray.
• the entire BEP out of chassis and remove the BEP from the system.
. 2
EV
Steps
Chapter 8 Replacement procedures
LOGIQ E9 S
Corresponding Graphic
BEP Cable to Backplane, J2 - BEP6
BEP Cable to Backplane J3 of GFI Configuration
(view inside the BEP)
M
ERVICE ANUAL
8 - 213