GE LOGIQ E9 Service Manual page 383

GE
D 5573152-100, R
IRECTION
Table 8-64
4.
Lay the Monitor flat.
Remove the two lower Phillips screws (1).
Loosen the upper Phillips screws (2). The
Monitor will be supported by the two upper
screws.
Slide the Monitor off of the Arm Assembly.
Remove the upper Phillips screws to re-
install into the replacement Monitor.
. 2
EV
Monitor removal - R5.x and later (Ergotron Arm)
Steps
Chapter 8 Replacement procedures
LOGIQ E9 S
Corresponding Graphic
19 and 23 inch Monitor (19 inch shown)
Upper Monitor mounting screw (2) and hole
OLED Monitor mounting screws and holes
M
ERVICE ANUAL
8 - 99