Table of Contents
Advertisement
Aftertreatment Device Manual Regeneration
When the manual regeneration is needed, symbol (1)
and service indicator (2) as shown to the right will be
displayed.
Perform manual regeneration in the following procedure.
IMPORTANT:
Park the machine in a safe area where exhaust
temperatures will not damage property or other
potential flammable sources.
Be sure that there are no flammable materials in the
engine area, including, but not limited to:
Coal dust.
Wood chip particles, saw dust.
Animal feed products (straw, hay, grain dust, etc.)
Inorganic man made debris; plastics, paper, refuse, etc.
Any other loose flammable debris.
Manual Regeneration Procedure
1. Park the machine in a safe and open place. Place the
transmission in neutral. Apply parking brake. Lower
the front attachment level to the ground.
2. Verify that items are set as shown below.
Forward/Reverse Lever
Forward/Reverse Switch (opt)
Accelerator Pedal
Parking Brake Switch
Loading Control Lock Switch (4)
Aftertreatment Device
Regeneration Inhibited Setting
Remaining fuel alarm does not light.
DEF/AdBlue® alarm does not occur.
3. Press the aftertreatment device regeneration switch
(3).
f
NOTE:
When "Aftertreatment Device Regeneration Inhibited"
is preset to ON, manual regeneration cannot be started.
Refer to page 1-56.
Refer to pages 1-5 and 1-34 for Automatic Regeneration
and more information.
OPERATING THE MACHINE
:
N (Neutral)
:
N (Neutral)
:
UP (OFF)
:
ON
LOCK ( )
:
OFF
:
5-13
1
2
Basic Screen
1
Rear View Camera Display
2
Basic Screen
(When Rear View Camera ON)
Manual Regeneration Request Screen
3
MNEK-01-280EN
MNEK-01-281EN
MNEK-01-282EN
4
3
MNEC-01-041
MDAA-05-002
Advertisement
Table of Contents
Troubleshooting
