Type Modbus; Selection And Activation Of The Sensor Type; Modbus Settings - Beko METPOINT BDL Instructions For Installation And Operation Manual

Operation BDL

14.2.3 Type Modbus

14.2.3.1 Selection and activation of the sensor type

First step: select a free sensor channel
Main menu  Settings  Sensor settings  B3
Second step: select the Modbus type
Main menu  Settings  Sensor settings  B3  Type text field  Modbus
Third step: confirm with
Now, a name (see Chapter
Main menu  Settings  Sensor settings  B3  VA  Use

14.2.3.2 Modbus settings

Main menu  Settings  Sensor settings  Modbus ID text field
Main menu  Settings  Sensor settings  B3  Modbus Settings
54
OK
12.2.2.7 Marking and setting text fields) can be entered.
Via Modbus, up to eight registry values
(from input or holding registers) of the sen-
sor can be read out.
Selection via the register tabs
activation by means of the respective
button.
Here the Modbus ID is entered which is
determined for the sensor, permissible val-
ues are 1 – 247, (ex. here
Setting of the Modbus ID at the sensor see
sensor data sheet.
Here, the serial transmission settings
drate, stop bit, parity bit, and timeout time
need to be defined.
Please refer to the data sheet of the used
sensor/transducer for this purpose.
Confirmation with OK.
Resetting to the initial settings by means of
the set to default button.
Va –Vh and
use
Modbus ID = 22)
bau-
METPOINT® BDL