14.2.8.2 Selection of the sensor type
See also Chapter
12.2.2.8 Configuration of analog sensors
Main menu Settings Sensor settings A1
Main menu Settings Sensor settings A1 Type text field
Note:
The text field "unit-consumption" is only editable in case of measurement values (Units) with volume per time
unit and thus also the consumption calculation.
For the marking and setting of the text fields see also Chapter
METPOINT® BDL
Unit
Measured value | Consumption rate
If
no sensor
was
type no sensor
will appear.
By pressing the text field
will go to the selection list of the sensor types
(see next step).
Selection of the required sensor type by press-
ing the respective button, here, for example 4-
20 mA.
Confirmation and acceptance with the
button.
Selection of the units by pressing the respec-
tive
measured value
or
text
fields.
Enter scale values for 4 mA and 20 mA, here
0 m³/h and 170m³/h.
If required, it is possible to enter a start value
for the consumption rate. For this, enter the
value into the
set total to
Confirmation of the entries by pressing the
button
12.2.2.7 Marking and setting text
Operation BDL
configured
yet,
the,
type no sensor,
you
OK
consumption rate
text
field.
OK
fields.
83