Storage And Transport - Beko METPOINT BDL Instructions For Installation And Operation Manual

7

Storage and transport

Despite all due care and attention, transport damage cannot be excluded. Therefore, check the
METPOINT ® BDL for possible transport damage subsequent to transport and removal of the packaging ma-
terial. The forwarding agent and BEKO TECHNOLOGIES or the BEKO TECHNOLOGIES agency shall be
informed immediately about any kind of damage.
Warning!
Overheating!
Overheating will destroy the evaluation unit. Observe the permissible storage and transport
temperature, as well as the permissible operating temperature (e.g. protect the measuring
device against direct sunlight).
Warning!
Damage possible!
Damage may occur to the METPOINT
suitable lifting tools.
Measures
• The METPOINT
nel.
• Only use suitable and technically sound lifting tools for the transport.
• In addition, observe the respectively valid regional provisions and directives.
Caution!
Danger through damaged components!
Do not start-up a damaged METPOINT
reliability, falsify the measuring results, and cause further damage.
METPOINT® BDL
® BDL must only be transported or stored by authorised and trained skilled person-
Store the METPOINT
closed, dry, and frost-protected room. The ambient tempera-
tures must not exceed/underrun the values indicated
on the type plate.
Protect the device against atmospheric influences even when
packaged.
The METPOINT
falling, and vibrations at the place of storage.
® BDL through improper transport, storage, or use of un-
® BDL. Defective components can impair the operational
® BDL in its original packaging in a
® BDL must be protected against tilting-over,
Storage and transport
9