14.7.2 Calibrating the touch screen
Main menu Settings Calibration touch screen
14.7.3 Cleaning
Main menu Settings Cleaning
Note:
Further information regarding cleaning measures can be found in Chapter 14.10
METPOINT® BDL
If required, the screen calibration can be
changed here.
Press
calibrate,
and a calibration cross will
appear 1. on the upper left, 2. on the lower
right, and 3. in the middle. These crosses
must be pressed consecutively.
When calibration is completed and the indica-
tion is averaged, confirm with OK.
If this is not the case, calibration can be re-
peated by means of
cancel
calibrate
again.
This function can be used to clean the
touch panel during the running measure-
ments.
If one minute does not suffice for the
cleaning process, the procedure can be
repeated at all times.
If the cleaning process is completed be-
fore, it can be stopped by pressing the
long-press-for-canceling
two seconds.
Operation BDL
and by pressing
button for one to
93