Modbus; Sd Card - Beko METPOINT BDL Instructions For Installation And Operation Manual
Graphic display-recorder
Hide thumbs
Also See for METPOINT BDL:
Table of Contents
Advertisement
Operation BDL
14.2.5.4 ModBus
Main menu Settings Device settings ModBus settings
14.2.5.5 SD card
Main menu Settings Device settings SD card Reset logger data base
Main menu Settings Device settings SD card Erase SD card
Note:
Further information regarding the SD card and the replacement of the card can be found in
Chapter 13.
66
Here the transmission parameters
ID, baud rate, stop bit and parity
By setting the tick for
enable Modbus
RTU(RS485), Modbus will be activated.
By pressing the
set to default
adjusted default values are set.
Default values: Baud rate:
Stop bit:
Parity:
By pressing the
reset logger data base,
currently stored data are blocked from use in
the BDL. However, the data remain stored on
the SD card, and are available for external
use.
By pressing the
erase SD card
the data are completely deleted from the SD
card.
Modbus
must be set.
button, the pre-
19200
1
even
the
button, all of
METPOINT® BDL
Advertisement
Table of Contents
