E1/T1 Configuration - Motorola iDEN Site Controller System Manual

Gen 3 Site Controller System Manual
E1/T1 Configuration
68P80801E30-A 5/1/2002
At the ACG# prompt, type: status
5.
This command checks the current status of Controller A.
ACG# status
Active/Standby Status:
MAC Address:
Standby ACG MAC Address
To configure the site controller for E1, enter "net e" at the ACG# prompt.
ACG# net e
Current NIC configuration is:
Signalling: E1
To configure the site controller for T1, enter "net t" at the ACG# prompt.
ACG# net t
Current NIC configuration is:
Signaling: T1
T1 line build out:
on port 0: 0
on port 1: 0
on port 2: 0
on port 3: 0
To configure the T1 Line Build Out settings, enter "net b" at the ACG#
prompt. For each port, enter:
Chapter 6 System Testing
Site Controller Verification
ACTIVE
XX:XX:XX:XX:XX:XX
(No Standby ACG)
6-7